Dulux Primer

Solvent-based, anti corrosive protective primer
Size
Paint Calculator
This product is not for online sale and can only be purchased from selected stores.
Your Measurements:
Amount Needed:
For the best result we recommend to use {coatAmount} for {productTitle}
Key information
  • Coverage 11 m²/litre
  • Drying Time Touch Dry 30 minutes
    Through Dry 8 hours
    Recoat 2 hours under normal conditions
  • Coats 1
Product Features
  • Lead and chromate free
  • Solvent-based, anti-corrosive protective primer

Product Description

Surface preparation product - a solvent-based, anti-corrosive protective primer for interior and
exterior ferrous metalwork including new and weathered iron and mild steel.

Health & Safety

Keep out of the reach of children, away from food, drinks and animal feed. Keep away from combustible material and sources of ignition – no smoking. Avoid contact with skin or eyes. Wear eye/hand protection. Do not breathe vapour/spray. Use only in well ventilated areas. Dry sanding, flame cutting and/or welding of the dry paint film will give rise to dust and/or hazardous fumes. Wet [sanding]/[flatting] should be used wherever possible. If exposure cannot be avoided by the provision of local exhaust ventilation, suitable respiratory protective equipment should be used. Remove as much paints as possible from brushes and rollers before cleaning. Store in a cool and shaded place. Container must be in a secure, upright position and be tightly closed. Do not use empty container for storing food. If swallowed seek medical advice immediately and show this container or label. In case of contact with eyes, rinse immediately with plenty of water and seek medical advice. In case of contact with skin wash immediately with soap and water or a proprietary skin cleanser. Do not use solvents or thinners. In case of fire use foam, dry powder, AFFF or CO2 fire extinguisher- Never use water Avoid release to environment. Refer to special instructions/Safety data sheet. Do not empty into drains or water course. Dispose of used container in compliance with local regulation. Safety data sheet available for professional user on request.

Tips & Advice

  • 1. Preparing the Surfaces
    Surface must be clean, dry and free from all defective or poorly adhering material,
    dirt, grease or wax etc. Previously painted surfaces should be thoroughly rubbed
    down using a suitable abrasive paper and then dusted off. Steel surfaces should be
    manually prepared by power or hand tool to SS542:2008 (code of practice for the
    painting of building). For optimum performance, new galvanized and aluminium
    surfaces should be cleaned and degreased, then pre-treated with an appropriate
    pre-treatment primer to ensure good adhesion.
  • 2. Cleaning
    Clean all equipment with Dulux Thinner 850-41 or white spirit immediately after use.
  • 3. Storing
    Observe the label precautions. Store in a cool, dry, well ventilated place away from sources of heat, ignition and direct sunlight. No smoking. Prevent unauthorised access. Containers which are opened should be properly resealed and kept upright to prevent leakage. Do not use or store any paint container by hanging on a hook. The Manual Handling Operations Regulations 1993 may apply to the handling of certain Paint Products. Products packed in containers of 5 litres and above will be marked with a guide weight; refer to these weights when carrying out an assessment. For flash points between 21 and 32 degrees Celsius store in accordance with the Highly Flammable Liquids and Liquefied Petroleum Gas Regulations 1972. The principles contained in the HSE guidance note Storage of Packaged Dangerous Substances, should be observed when storing this product. Store separately from oxidising agents, strongly alkaline and strongly acidic materials, amines, alcohols and water.
Fetching the data, please wait...